МЕХАНИЧЕСКАЯ ТРАНСМИССИЯ В БЛОКЕ С ГЛАВНОЙ ПЕРЕДАЧЕЙ В СБОРЕ > УСТАНОВКА |
1. INSTALL REAR ENGINE MOUNTING BRACKET |
Install the rear engine mounting bracket with the 5 bolts.
2. INSTALL FRONT ENGINE MOUNTING BRACKET |
Install the front engine mounting bracket with the 3 bolts.
3. INSTALL ENGINE MOUNTING BRACKET LH |
Install the engine mounting bracket LH with the 4 bolts.
4. INSTALL WIRE HARNESS CLAMP BRACKET |
Install the wire harness clamp bracket with the bolt.
5. INSTALL MANUAL TRANSAXLE ASSEMBLY |
Align the input shaft with the clutch disc and install the front transaxle to the engine.
Install the 5 bolts.
6. INSTALL STIFFENER PLATE LH |
Install the stiffener plate with the 4 bolts.
7. INSTALL STIFFENER PLATE RH |
Install the stiffener plate with the 4 bolts.
8. INSTALL OIL PAN INSULATOR |
Install the oil pan insulator with the 2 bolts.
9. INSTALL AIR TUBE SUPPORT |
Install the bracket with the 2 bolts.
10. INSTALL STARTER ASSEMBLY (for 2AD-FHV) |
Install the starter assembly with the 2 bolts.
Install the wire harness with the nut.
Connect the starter connector.
Install the bracket with the bolt.
Install the ground cables to the manual transaxle with the 2 bolts.
11. INSTALL NO. 1 AIR TUBE |
Install the No. 1 air tube with the 2 bolts and tighten the band.
Connect the wire harness with the 3 clamps.
12. INSTALL ENGINE WIRE (for 2AD-FHV) |
Install the engine wire to the engine.
13. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH |
Смажьте шлицевую часть вала внутреннего шарнира трансмиссионным маслом.
Совместите шлицы валов и вбейте приводной вал с помощью латунного стержня и молотка.
14. INSTALL FRONT DRIVE SHAFT ASSEMBLY RH |
Смажьте шлицевую часть вала внутреннего шарнира трансмиссионным маслом.
Совместите шлицы вала и плотно вставьте приводной вал.
Вверните 2 болта кронштейна подшипника.
15. INSTALL REAR ENGINE MOUNTING INSULATOR (for 2AD-FHV) |
Install the bolt which secures the engine mounting bracket to the mounting insulator.
16. INSTALL ENGINE ASSEMBLY WITH TRANSAXLE (for 2AD-FHV) |