МЕХАНИЧЕСКАЯ ТРАНСМИССИЯ В БЛОКЕ С ГЛАВНОЙ ПЕРЕДАЧЕЙ В СБОРЕ > СНЯТИЕ |
1. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE (for 2AD-FHV) |
2. REMOVE REAR ENGINE MOUNTING INSULATOR (for 2AD-FHV) |
Remove the bolt, and detach the engine mounting insulator RR from the engine mounting bracket RR.
3. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH |
С помощью SST снимите передний приводной вал.
4. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH |
Выверните 2 болта и вытяните приводной вал вместе с корпусом подшипника вала.
Снимите приводной вал с трансмиссии в блоке с главной передачей.
5. REMOVE ENGINE WIRE (for 2AD-FHV) |
Remove the engine wire from the engine.
6. REMOVE NO. 1 AIR TUBE |
Disconnect the 3 clamps, and disconnect the wire harness.
Loosen the hose clamp, and remove the 2 bolts and the No. 1 air tube.
7. REMOVE STARTER ASSEMBLY (for 2AD-FHV) |
Remove the bolt and disconnect the wire harness clamp.
Remove the 2 bolts and disconnect the ground cables from the manual transaxle.
Disconnect the starter connector.
Remove the nut and disconnect the wire harness.
Remove the 2 bolts and starter assembly.
8. REMOVE AIR TUBE SUPPORT |
Remove the 2 bolts and the bracket.
9. REMOVE OIL PAN INSULATOR |
Remove the 2 bolts and the oil pan insulator from the stiffener plate.
10. REMOVE STIFFENER PLATE LH |
Remove the 4 bolts and the stiffener plate from the engine and transaxle assembly.
11. REMOVE STIFFENER PLATE RH |
Remove the 4 bolts and the stiffener plate from the engine and transaxle assembly.
12. REMOVE MANUAL TRANSAXLE ASSEMBLY |
Remove the 5 bolts and the manual transaxle assembly from the engine.
13. REMOVE WIRE HARNESS CLAMP BRACKET |
Remove the bolt and the wire harness clamp bracket.
14. REMOVE ENGINE MOUNTING BRACKET LH |
Remove the 4 bolts and the engine mounting bracket LH from the transaxle.
15. REMOVE FRONT ENGINE MOUNTING BRACKET |
Remove the 3 bolts and the front engine mounting bracket.
16. REMOVE REAR ENGINE MOUNTING BRACKET |
Remove the 5 bolts and the rear engine mounting bracket.